Details that should be paid attention to during the application of the rubber roller

2021-09-15

Author：

Views：

　　There are many details that should be paid attention to in the application of rubber rollers, which are briefly described below:

　　1. When the machine is turned on for heating, it should be checked whether the silicone roller rotates normally. When the machine is turned off, the residual temperature delay should be set finely to see if it is normal. If it is not possible to shut down directly (the residual temperature delay is usually set at 40-50 minutes);

　　2. During the work, if there is a power failure or a sudden shutdown due to other reasons, you should immediately put on gloves, and turn the rubber roller while removing it and placing it elsewhere to dissipate heat, so as to prevent uneven heat from burning the silicone roll;

　　3. When changing the rubber roller to tighten the silica gel, it should wait until the silica gel is heated to the required temperature before locking it firmly, but it should not be too tight;

　　Fourth, the silicone roller should usually be kept clean on the surface, even if the transfer film sundries are prevented from sticking to the surface of the rubber roller, if there is dirt on the surface, the surface can be cleaned with denatured alcohol. If there is stubborn dirt, it can be polished with fine sandpaper.

　　5. Like other printing rubber rollers, when the silicone roller is used or stored, it should not collide with other hard objects (such as wrenches) and squeeze it. Stay away from corrupted items;

　　6. The temperature of the silica gel is usually around 190 degrees, and the transfer can be done normally. In the environment where the product transfer is qualified, the pressure and temperature of the silica gel roller should be reduced.

■

The main content of natural rubber roller maintenance

—

2021-09-15